How to install the cctv power supply - STEADY

Firstly:

Take out the bracket and prepare the tools and parts: necessary tools such as plugs, screws, screwdrivers, small hammers, electric drills, etc.; according to the pre-determined installation position, check the size and model of the plugs and self-tapping screws, and try the bracket screws and Check whether the screw port of the camera base is suitable, whether the pre-buried pipeline interface is handled well, whether the test cable is unblocked, and then enter the installation procedure when it is ready.


Next:

Take out the camera, carefully install the lens according to the determined camera lens model and specifications (infrared integrated cameras do not need to install the lens), be careful not to touch the lens and CCD (marked in the figure) with your hands, confirm that it is firmly fixed, and then connect Connect the power supply to the host or use a monitor, small TV, etc. on site to adjust the aperture and focal length.


third:

Take out brackets, plugs, screws, screwdrivers, hammers, electric drills and other tools

Install the bracket according to the position determined by the construction drawings. After checking that it is firm, install the camera according to the design direction; (before determining the installation bracket, test it with power on at the installation position, so as to obtain a more reasonable monitoring effect).


fourth:

If there is a lot of dust outdoors or indoors, you need to install the camera cover. After the second step, install the cover directly from here.

①Open the upper cover and rear baffle of the shield;

② Pull out the fixing metal sheet and fix the camera;

③ Put the power adapter into the shield;

④Reset the upper cover and rear baffle, straighten out the cables, fix them, and install them on the brackets.

fifth:

Insert the soldered BNC plug of the video cable into the socket of the video cable (align the two fixing posts of the video socket of the camera with the two notches of the plug, and then rotate clockwise after insertion), and confirm that the fixing is firm and the contact is good.


sixth:

Insert the power output plug of the power adapter into the power socket of the surveillance camera, and confirm the firmness.


seventh:

Connect the other end of the cable to the video input port of the control panel or monitor (video set) in the same way, making sure it is firm and in good contact.


At last:

Turn on the power of the monitoring host and the camera, adjust the angle of the monitoring camera to a predetermined range through the monitor, and adjust the focal length and sharpness of the camera lens, and enter the adjustment process of the video recording equipment and other control equipment.